10 Error Messages
206 Pulse Laser Station NPL-302 Series Instruction Manual
Angle 10.1
STN Setup has to be in F1/F2 101.1
You selected ANG>F1/F2 without an F1/F2 measurement in Station Setup.
Press any key to return to the previous screen. Then go to Station Setup and take
F1/F2 measurement to the BS.
Cogo 10.2
NO Result 102.1
The system was unable to calculate an area because points were not entered in the
correct order.
Press any key to return to the Cogo menu. Then enter the points in the correct order.
Same Coordinate 102.2
The point or coordinate that you entered is identical to the previous input point.
Press any key to return to the point input screen. Then use a different point.
XY-coordinate is required 102.3
The input point does not have XY (NE) coordinates.
Press any key to return to the point input screen. Then enter a point that has X and
Ycoordinates.
Communications 10.3
If an error is detected during uploading of data, the instrument aborts the upload
process and displays one of the following messages.
Check Data 103.1
There are errors in the uploaded data. The uploaded data contains errors, such as an
alphabetic character in a coordinate field.
Press any key. Then check the specified line in the data.
DUPLICATE PT 103.2
The uploaded data contains a duplicate PT.
Press any key. Then check the specified point in the data.
To Next Page
