Nikon NPL-352 - Programs

Error Messages 10
Pulse Laser Station NPL-302 Series Instruction Manual 209
MAX 32Jobs 106.4
You are trying to create a new job when the maximum number of jobs (32) is
already stored.
Press any key to return to the Job Manager. Then use the
DEL softkey to delete old
jobs.
Programs 10.7
NO Stn Setup 107.1
You did not perform a station setup or BS check before entering the Programs
function.
C
Warning – Selecting Continue does not resume the last ST record. You
should only use the Continue option if you are sure that the previous ST
coordinates and the current HA orientation are correct. Otherwise, records in
the Programs function may not be correct.
XY&Z coordinate are required 107.2
Three-dimensional coordinates are required in S-Plane function.
Press any key to return to the point input screen. Then enter a three-dimensional
point.
To ... Press ...
go to the Stn Setup menu [2] or select
Stn Setup
return to the BMS [ESC]
go to the Programs menu [1] or select
Continue