Basic Card Printing Methods
15
5 Click [Print].
• Printing starts.
• Cards are pulled into the printer and the LED Indicator
blinks blue.
[Now Printing] appears on the LCD Panel.
• If the cards are not loaded, [Card Empty] appears on
the LCD Panel.
Removing Cards
The factory default is for printed cards to be ejected from Card Ejection Slot (Left).
1 Removing cards from the Card Stacker.
• You can remove loaded cards from the slit on the side
of the Card Stacker (see diagram at right).
The Card Ejection Slot (Left) Card Stacker has a maximum capacity of approximately
250 cards.
When ejecting cards from the Card Ejection Slot (Left), empty the Card Stacker when
it has approximately 250 cards.
The factory default is set so that correctly printed cards are output from the Card
Ejection Slot (Left), and cards with errors are output from Card Ejection Slot (Right).
→See "Switching the Card Ejection Slot" on page 46 for information about switching the card ejection
location.
→See the "Easy Setup Guide" for instructions on removing the Card Stacker.
The factory default status is to have the front face facing down for single-sided
printing, and facing up for double-sided printing.
→See "Set the Orientation of Cards to Eject" on page 49 for the orientation of cards to eject.
To Next Page
Loading...
Need help?
General
