Operating the Printer Safely
3
Under the following conditions images on cards may deteriorate or cards may
warp after printing.
The surface of the card is in contact for an extended period of time with a
vinyl card holder or synthetic leather or other material that contains
plasticizer.
The surface of the card is exposed to direct sunlight for an extended period
of time.
The card is repeatedly rubbed against a hard object.
The faces of two cards are in contact for an extended period of time.
The card is kept for an extended period of time in a very hot location such as
a car parked in the sun.
The card is bent, or used with excessive force.
If a card with a magnetic strip is placed near a magnetic source, the data on the
strip may become corrupted.
Additionally, if the IC card is bent, or used with excessive force, the IC chip may
be damaged.
Regulations for this product FCC Regulations
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Do not make any changes or modifications to the equipment unless otherwise specified
in the manual.
If such changes or modifications should be made, you could be required to stop
operation of the equipment.
To Next Page
Loading...
Need help?
General
