Full Color Card Printer
80
Other Troubles
When These Solutions Don't Work...
Contact your reseller if errors appear which are not included in this manual or when an error
cannot be cleared.
When contacting your reseller, provide them with the content of the message and the
error code (XX-XX) that appears on the right side of the LCD Panel.
Some or all of the printed
area are cloudy.
Is the Transfer Film running between the two pins on top of the
Transfer Film Cassette?
Make sure that the Transfer Film is correctly loaded.
→See "Transfer Film Replacement" on page 19 on how to install the Transfer
Film.
Is the pin on top of the Transfer Film Cassette attached correctly?
Make sure that the pin on top of the Transfer Film Cassette is attached
correctly.
→See "Transfer Film Replacement" on page 19 on how to attach the pin on top of
the Transfer Film Cassette.
Secondary transfer conditions (speed and temperature) are not
optimum.
Set secondary transfer conditions in accordance with cards used.
→See "Setting the Types of Card to Use" on page 42 for instructions on setting
secondary transfer conditions.
The power cannot be turned
on.
Make sure the power cable is connected.
Data cannot be sent to the
printer.
Make sure the USB cable is connected.
Make sure the network is connected.
The printer cannot connect to
the network.
Confirm User Mode network settings.
See "Changing Network Connection Settings" on page 51 for how to
confirm network settings.