Operating the Printer Safely
1
Operating the Printer Safely
The following precautions must be observed to assure safe operation of the printer.
Also, do not do anything that is not described in this manual. Doing so may cause an
unexpected accident.
Failure to observe the following items while using the printer may cause fire,
electric shock or other unexpected accident.
Installation location Do not install the printer in a damp or dusty location.
Do not install the printer near flammable or explosive materials or heater, stove or
other device that produces heat.
Place the printer away from walls, as shown in the diagram below, to maintain air
flow. Also, maintain at least 30 cm of open space above the printer.
Blocking the vents may cause the printer to overheat and catch fire.
Power supply
Use a dedicated power cable and do not use an extension cord with multiple outlets.
Be sure to remove any dust from the plug and outlet.
Humidity produces a micro-current on the surface causing overheating or fire.
Do not damage or modify the Power Cable. Also, do not place heavy objects, pull,
or bend excessively.
Do not plug in or unplug the Power Cable if your hands are wet.
Ensure a ground wire is connected.
When connecting the ground wire, note the following cautions.
• Recommended connections for ground wires
Outlet ground terminal
Ground terminals installed as type A, B, or C
A copper rod 65 cm or longer buried in the ground.
• Not permitted for ground wires
Gas piping (risk of fire or explosion.)
Water pipes or taps (water pipes that include plastic piping cannot act as a ground.
However, if a water pipe is configured to act as a ground, then connection of a ground
wire is permitted.)
Telephone line ground wires or lightning conductors (danger of high current flow in the
event of a lightening strike.)
Be sure to turn off the power and unplug the plug from the outlet before moving the
printer.
Pull on the plug, not the cable, when unplugging it from an outlet.
Handling Do not use flammable sprays near the printer.
Do not touch anything inside the printer unless specified in this manual.
15cm
30cm
10cm
15cm
15cm15cm
30cm
The left illustration indicates
distance values when the Card
Stacker is attached.
To Next Page
Loading...
Need help?
General
