Full Color Card Printer
62
Cleaning the Reverse Roller
If card delivery from the reverse section to the secondary transfer feeding roller is not possible,
then clean the Reverse Roller.
Be sure to turn off the printer before cleaning the rollers.
Read the cautions in "Before Cleaning" on page 54.
1 Turn off the power.
2 Open the top cover, and remove the
Card Case.
• Hold the Card Case handle, and remove.
3 Open the Front Cover and Top Cover.
• Press the open over switch, and pull the Front Cover
forward.
• Hold the handle of the Top Cover and lift to open.
• If you do not open the Front Cover, then you cannot
open the Top Cover.
4 Rotate the reverse knob, and locate the
reverse section roller as in the diagram.
• When checking inside the reverse section, remove the
Cleaning Roller and Cleaning Tape Cassette.
→See "Cleaning Tape Replacement" on page 22 and
"Cleaning the Cleaning Roller" on page 57 for
instructions on removing the Cleaning Roller and
Cleaning Tape Cassette.
Reverse
Knob
Reverse Section
Reverse Feeding
Knob
To Next Page
Loading...
Need help?
General
