Full Color Card Printer
2
Failure to observe the following items while using the printer may cause injury
or a malfunction.
The cooling fan is always running for cooling the inside of the printer. This is
not a malfunction.
Contact your reseller if there is a current leak.
The printer may cause static, flickering or interrupt reception of televisions
or radios if they are too close to the printer.
Regarding copyrights
Using portraits (photos or images) or copyrighted material (illustrations or
logos) without the permission of their owners is prohibited by law.
Do not use copyrighted images without permission or for illegal activities.
The lower part of the Top Cover, the
printer internal heat roller section,
and the thermal head section get
very hot. Ensure you do not touch
these three locations.
Installation location Do not install the printer on an unstable table, on a slant, or any place where there
is excessive vibration.
Do not install the printer in a location susceptible to rapid fluctuations in temperature.
Do not install the printer in a location exposed to direct sunlight.
Power supply Do not use an under-rated extension cord.
Handling Do not place heavy items on the printer and do not lean on the printer.
When moving the printer, carry it as shown below.
While the printer is operating, do not turn off the power, unplug the power cable, or
look inside the printer.
Heat Roller Section
High Temperature
Warning Label
Thermal Head Section
To Next Page
Loading...
Need help?
General
