A-2 Appendix A - Material Safety Information
1HMSDS - MULTEMP PS NO 2-A 07-350 (Continued)
SECTION III - Physical/Chemical Characteristics
Appearance/Odor WHITE PASTE; SLIGHT ODOR
Boiling Point NA
Melting Point 190 C
Vapor Pressure NA
Specific Gravity 0.92
Solubility in Water NEGLIGIBLE
Container Type R
Container Pressure Code 1
Temperature Code 4
Product State Code S
SECTION IV - Fire and Explosion Hazard Data
Flash Point 215
Flash Point Method SCC
Lower Explosion Limit NA
Upper Explosion Limit NA
Extinguishing Media
DRY CHEMICAL, WATER FOG, CO2, FOAM,
SAND/EARTH
Special Fire Fighting Procedures
DENSE SMOKE. FIRE FIGHTER WEAR
APPROVED SCBA. DO NOT USE WATER
EXCEPT FOG
SECTION V - Reactivity Data
Stability YES
Stability Conditions to Avoid AVOID OVER-HEATING
Materials to Avoid STRONG OXIDIZERS SUCH AS HYDROGEN
PEROXIDE, BROMINE, & CHROMIC ACID
Hazardous Decomposition Products CARBON MONOXIDE & DIOXIDE, OXIDE OF
NITROGEN
Hazardous Polymerization NO
Polymerization Conditions to Avoid WILL NOT OCCUR
SECTION VI - Health Hazard Data
Route of Entry: Skin U
Route of Entry: Ingestion U
Route of Entry: Inhalation U
Health Hazards - Acute and Chronic {EYES}
Emergency/First Aid Procedures
{EYES} IMMEDIATELY FLUSH W/ WATER
FOR AT LEAST 15 MIN. {SKIN} REMOVE
EXCESS W/ CLOTH OR PAPER & WASH
THOROGHLY W/ SOAP & WATER. {INGEST}
CONSULT PHYSICIAN. DO NOT INDUCE
VOMITING {INHALE} KEEP VICTIM WARM &
QUIET. REMOVE TO FRESH AIR
To Next Page
Loading...
Need help?
General