EasyManuals Logo

Nordson Asymtek Spectrum Series User Manual

Nordson Asymtek Spectrum Series
238 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #233 background imageLoading...
Page #233 background image
Glossary G-5
Syringe: A reservoir containing the dispensing fluid
that is usually attached to the Dispensing Valve.
Tactile Sensor: A sensor located adjacent to the Needle
Sensor that is used to calculate the Z-axis offset between
the Height Sensor probe and dispensing needle tip.
Tooling Air Regulator and Gauge: The Tooling Air
Regulator and Gauge controls air pressure for Stop Pins
and Lift Tables/Bar Clamps.
Underfill: The process of flowing epoxy underneath a
flip chip on a PWB to completely seal the solder bumps.
V: Abbreviation for volt as in VAC (Volts Alternating
Current). See also AC, DC.
Valve Air Pressure Regulator and Gauge: The Valve
Air Pressure Regulator and Gauge set controls the air
pressure that actuates some Dispensing Valves
(DV-7000, DV-8000, and DP-3000) during dispensing.
Valve: See Dispensing Valve.
Viscosity: Viscosity is a measurement of the flow
properties of a fluid. High viscosity fluids have a high
resistance to flow and low viscosity fluids have a
low resistance.
Vision Card: Computer card that receives video signals
from the Camera and performs fiducial image capture.
Vision System: Includes the camera, light source,
computer hardware and software, and the monitor.
Water Trap: The facility air supply may contain
moisture that can damage the dispensing system. The
water trap condenses this moisture before it enters the
dispenser pneumatic system.
Workpiece: Any surface, part, or element (usually a
PWB) that is being dispensed upon. Workpieces may be
installed in a carrier such as a lead frame or Auer boat.
X-Axis: Left to right movement of the Dispensing Head
in the dispensing chamber.
X-Beam: The apparatus that spans the width of the
dispensing chamber. The Dispensing Head is mounted
to the X-Beam and slides along it in the X-Axis.
Includes mechanical pulleys for the X-Axis cables.
Y-Axis: Forward and backward movement of the
Dispensing Head in the dispensing chamber.
Z-Axis: Up and down movement of the Dispensing
Head in the dispensing chamber.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Nordson Asymtek Spectrum Series and is the answer not in the manual?

Nordson Asymtek Spectrum Series Specifications

General IconGeneral
BrandNordson
ModelAsymtek Spectrum Series
CategoryDispenser
LanguageEnglish

Related product manuals