Nortel CallPilot - Page 163

Updating and configuring the BIOS 163
To configure the BIOS
Note: Only options that need to be changed from their defaults are
described below. As you perform this procedure, you should still validate
that all BIOS settings conform to the values listed in "BIOS settings"
(page 158).
Step Action
1
During the server startup and while the startup diagnostics still
appear on the screen, press F2 to display the Main menu screen.
2
Press BIOS Default (F9) to load the default BIOS settings.
Result: You are prompted to confirm the settings.
3
Choose Yes, and then press Enter.
Result: The Main menu reappears.
4
Use the right and left arrow keys to choose the Advanced screen.
Result: A list of configuration sections appears.
5
Configure the sections as follows:
•
Boot-up Diag Screen: Enabled
•
Num Lock: ON
•
Sleep Button: Disabled
6
Use the right and left arrow keys to choose the Server screen.
Result: A list of configuration sections appears.
7
Configure the sections as follows:
•
Assert NMI on PERR: Disabled
•
Assert NMI on SERR: Disabled
8
Use the right and left arrow keys to choose the Boot screen.
Result: A list of configuration sections appears.
9
Ensure the boot device order is defined as follows:
•
first: floppy drive
•
second: hard drive
•
third: CD-ROM drive
Note 1: The CallPilot operating system requires that the first
startup be completed from the CD-ROM drive. To achieve this
Nortel CallPilot
703t Server Maintenance and Diagnostics
NN44200-702 01.03 Standard
5.0 3 April 2007
Copyright © 2007, Nortel Networks Nortel Networks Confidential
.