Conducting TSTSERIO tests 47
Result: The system runs the Net Stop command utility.
3
Type Exit, and then press Enter to exit the Command Prompt
window.
—End—
Conducting TSTSERIO tests
The TSTSERIO command performs local loopback tests of the serial
communication ports from the server runtime environment.
Note: Before conducting these tests, shut down the appropriate
services. See "Shutting down services" (page 45).
CAUTION
By stopping the services on COM 1 or COM 2, you lose the
support access feature.
CAUTION
By stopping the services on COM 2, you stop call processing on
CallPilot.
TSTSERIO command syntax
The syntax for the TSTSERIO command is as follows:
TSTSERIO [/?] /P:comport [/S:subtstname] [/L:loops]
Flag Requiremen
t
Description
? n/a Displays Help.
/P:comport Required Specifies the symbolic port name assigned to
the port you want to test.
/S:subtstnam
e
Optional Specifies a TSTSERIO subtest. See the
table below for a description of the available
subtests.
/L:loops Optional Specifies the number of times (up to a
maximum of 65 535) to execute the requested
test. The default number of tests is 1. A value
of 0 infinitely loops until you enter Ctrl+C.
Nortel CallPilot
703t Server Maintenance and Diagnostics
NN44200-702 01.03 Standard
5.0 3 April 2007
Copyright © 2007, Nortel Networks Nortel Networks Confidential
.
To Next Page
Loading...
