Nortel CallPilot - Updating and Configuring the BIOS

162 Chapter 13 Working with the CallPilot server BIOS
Updating and configuring the BIOS
BIOS update availability
ATTENTION
The BIOS installed on the CallPilot server must be version P07_64 or later.
BIOS updates are provided by Nortel on a floppy disk (NTRH8057).
CAUTION
Do not power off or restart the server before the BIOS update is
complete. If you do, the BIOS will become corrupted.
If the server does lose power during BIOS update (for example,
because of a power outage or lightning strike) you will need to
perform the BIOS recovery procedure on "To recover from a
corrupted BIOS" (page 165).
Note: For a complete list of BIOS settings, refer to "BIOS settings"
(page 158).
To update the BIOS
Step Action
1
Insert the BIOS update disk (NTRH8057) into the floppy disk drive of
the server.
2
Restart the server. For instructions, refer to the Installation and
Configuration Task List (NN44200-306).
Result: The server boots from the floppy disk and the BIOS update
begins automatically.
3 When prompted, press 1, and then press Enter.
4
When the BIOS update is finished, the server restarts automatically.
5
While the server is restarting, remove the BIOS update disk from the
server’s floppy disk drive.
6
When the server has rebooted, continue with "To configure the
BIOS" (page 163).
—End—
Nortel CallPilot
703t Server Maintenance and Diagnostics
NN44200-702 01.03 Standard
5.0 3 April 2007
Copyright © 2007, Nortel Networks Nortel Networks Confidential
.