Working with the Channel Monitor 69
IF you want to stop or start THEN
Repeat this step for each DSP.
only one or several channels that
are associated with a DSP
check the check box for each
channel that you want to stop or
start.
4
Click Courtesy Stop, Stop, or Start as required.
Result: If you clicked Courtesy Stop or Stop, you are asked to
confirm the Courtesy Stop or Stop. Click OK.
The selected channels change to idle or on-duty status, according
to the action you chose.
If the buttons are not available, wait a few seconds for the screen
to refresh:
•
The Start button is available only when a component is in the
Idle state.
•
The Courtesy Stop and Stop buttons are available only when a
component is in one of the following states: Idle, Active, Remote
Alarm, Local Alarm.
—End—
Working with the Channel Monitor
The Channel Monitor shows the status of call channels. The call channels
are the connections between the server and the switch that carry the call
signals to CallPilot.
To view or work with call channel states
Step Action
1
Run CallPilot Manager and log in.
2
In CallPilot Manager, click Maintenance → Channel Monitor.
Result: The Channel Monitor screen appears, showing the channels
associated with each link.
Nortel CallPilot
703t Server Maintenance and Diagnostics
NN44200-702 01.03 Standard
5.0 3 April 2007
Copyright © 2007, Nortel Networks Nortel Networks Confidential
.
To Next Page
Loading...
