22 Chapter 3 Troubleshooting your CallPilot system
Left -
Ready
Green
Center -
Activity
Green
Right -
Error
Amber Description
Off Blinking On Cleaning is in progress
Off Off Blinking
•
Unrecoverable tape drive failure has
occurred.
• Cartridge has failed
•
Microcode download failure has
occurred
Note: If the LED states indicate an error, contact your Nortel technical support
representative.
CD-ROM drive LED states
The CD-ROM drive’s status LED is located on the drive’s front panel. Refer
to the following table when interpreting the CD-ROM drive’s status:
IF the CD-ROM
drive LED is THEN
off the CD-ROM drive is idle.
on
the CD-ROM drive is being accessed.
Interpreting rear panel LEDs
This section describes LED states visible at the back of the 703t server.
MPB96 DS30 connection link LED states
Refer to "Slot definition and numbering" (page 172) for the slot position of
the MPB96 boards in your server.
"MPB96 board" (page 138) shows the location of three green LEDs on the
MPB96 card bracket.
When THEN
all three are On the cables are connected properly.
one or more are Off
•
there is no connection to the switch.
•
the connection to the switch is intermittent.
•
the DS30 clock signal coming from the
MGate card (NTRB18CA) is not working
correctly.
You should:
Nortel CallPilot
703t Server Maintenance and Diagnostics
NN44200-702 01.03 Standard
5.0 3 April 2007
Copyright © 2007, Nortel Networks Nortel Networks Confidential
.
To Next Page
Loading...
