Nortel CallPilot - Replacing the Tape Drive

Replacing the tape drive 109
Tighten the screws firmly.
7
Ensure that all media drive cable connections are secure.
Note: Connectors could be dislodged when you slide the hard
drive all the way inside the bay.
CAUTION
If the hard drive cable connections are loose, data loss,
data corruption, or system malfunction can occur.
8
Reinstall the fans (if removed) and upper fan holder foam.
•
For instructions on reinstalling the fans, see "Install front system
fan" (page 94).
•
For instructions on replacing the upper fan holder foam, see "To
replace the upper fan holder foam" (page 88).
9
Reinstall the server side cover.
10
Reconnect the peripheral device and power cables.
11 Power up the server.
12
Rebuild the drive in the RAID system pack.
The rebuild copies the data from the operating hard drive to the new
hard drive. For instructions, see Chapter 10 "RAID operations"
(page 121)
Result: Hard drive replacement is complete.
—End—
Replacing the tape drive
The tape drive is preinstalled at the factory. However, if it becomes faulty,
follow the procedure in this section to replace it.
CAUTION
Use only a tape drive that is supplied by Nortel.
Nortel CallPilot
703t Server Maintenance and Diagnostics
NN44200-702 01.03 Standard
5.0 3 April 2007
Copyright © 2007, Nortel Networks Nortel Networks Confidential
.