Nortel CallPilot - Page 46

46 Chapter 5 Using serial port diagnostic tools
CAUTION
By stopping the services on COM 2, you stop call processing on
CallPilot.
Service to stop for COM 1 testing
•
Services to stop for COM 2 testing
•
CallPilot SLEE Service
•
CallPilot MWI Service
•
CallPilot Access Protocol Emulator
•
CallPilot Blue Call Router
•
CallPilot Call Channel Router
•
CallPilot Time Service
• Routing and Remote Access
Net Stop command
Use the Net Stop command to stop a specified service on a serial port.
Net Stop command syntax
The Net Stop command uses the following syntax:
net stop "service_name"
ATTENTION
You must restart the services that you shut down through the Net Start command
after running the diagnostic. For details, see "Restarting services" (page 49).
To invoke the Net Stop command from Windows
Step Action
1
Click Start → Programs → Accessories → Command Prompt.
Result: The Command Prompt window appears.
2
At the Command prompt, type net stop "service_name", and
then press Enter.
Note: The quotation marks are required, as in the example
above.
Nortel CallPilot
703t Server Maintenance and Diagnostics
NN44200-702 01.03 Standard
5.0 3 April 2007
Copyright © 2007, Nortel Networks Nortel Networks Confidential
.