The Maintenance page 59
Section
Description
Maintenance This section shows the state of the selected component.
Use this section to start and stop a component before
running a diagnostic test.
This section appears only for components on which you
are allowed to perform maintenance administration.
For more information about working with component states,
see the following sections:
•
"Viewing component states" (page 60)
•
"Starting and stopping components" (page 62)
Diagnostics Use the Diagnostics section to run one or more diagnostic
tests, or to view the results of the last diagnostic tests that
were run on the selected component.
This section appears only for components on which you
are allowed to run diagnostics. For more information about
running diagnostics, see the following sections:
•
"Running integrated diagnostics" (page 64)
•
"Viewing the last diagnostic results" (page 66)
Maintenance activities for each component
"Maintenance activities" (page 59) identifies the maintenance activities you
can perform for each component listed in the component tree.
Maintenance activities
Component
Start,
stop?
Courtesy
stop?
Diagnostics
available?
Replaceable
?
Media Bus Yes No No No
MPB board Yes No Yes Yes
Time Switch No No No No
Multimedia
channels
Yes Yes No No
Note: The MGate card and DS30X cable are replaceable. If you are having
problems with the DS30X link, determine if either one or both of those items are
causing the problem and need to be replaced.
Nortel CallPilot
703t Server Maintenance and Diagnostics
NN44200-702 01.03 Standard
5.0 3 April 2007
Copyright © 2007, Nortel Networks Nortel Networks Confidential
.
To Next Page
Loading...
