Nortel CallPilot - Page 63

Starting and stopping components 63
Note: If you want to start or stop more than one or two multimedia or
call (DS30X) channels, use the Multimedia Monitor or Channel Monitor.
For instructions, see "Channel and Multimedia Monitors" (page 57).
Component
Effect of stopping
Media Bus Takes all call processing resources out of service.
MPB board Takes all call processing resources on the selected
board out of service.
Time Switch You cannot perform maintenance administration on
the time switch.
Multimedia Channel Takes the selected Multimedia Channels out of service.
DS30X link Takes the selected DS30X link and the channels that
belong to that link out of service.
Channels Takes the selected DS30X channel out of service.
To start or stop a component
Step Action
1
Run CallPilot Manager and login.
2
In CallPilot Manager, click Maintenance → Maintenance Admin.
Result: The Maintenance screen appears.
3 Click the plus sign (+) beside the CallPilot server to expand the
component tree.
4
Continue clicking the plus sign (+) until the component with which
you want to work is visible.
5 Click the hardware component that you want to start or stop.
Result: The Maintenance screen refreshes to show details about
the component.
6
Scroll down to the Maintenance section.
7
Click Courtesy Stop, Stop, or Start as required.
—End—
Nortel CallPilot
703t Server Maintenance and Diagnostics
NN44200-702 01.03 Standard
5.0 3 April 2007
Copyright © 2007, Nortel Networks Nortel Networks Confidential
.