EasyManua.ls Logo

NXP Semiconductors QorIQ LX2160A - Page 8

NXP Semiconductors QorIQ LX2160A
116 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Table 3. LX2160ARDB features (continued)
LX2160ARDB feature Specification Description
I2C Six I2C controllers
(I2C1, I2C2, I2C3,
I2C4, I2C5, and I2C6)
Most system devices (other than UEFI) are accessed via I2C1, which
is multiplexed to isolate address conflicts and reduce capacitive load
I2C1 is translated to 3V3_SB, allowing programming access to
devices, such as power controllers, clocks, and memories, while the
system is off
I2C2 is only used for SDHC1_CD_B and SDHC1_WP
I2C3 is only used for CAN1 input/output
I2C4 is only used for CAN2 input/output
I2C5 is used for UEFI support (memory and RTC)
I2C6 is used for optional AQR107 PHY access
Serial ports Two UART ports
(UART1 and UART2)
A dual-stack DB9 male connector providing two UART connectors, each
connected through an RS-232 transceiver
USB 3.0 Two high-speed USB
3.0 ports with
integrated PHYs
Supports super-speed (5 Gbit/s), high-speed (480 Mbit/s), full-speed
(12 Mbit/s), and low-speed (1.5 Mbit/s) operations
USB#1 3.0 port is connected to a Type A host connector
USB#2 3.0 port is configured as On-The-Go (OTG) with a Micro-AB
connector
Ethernet Two tri-speed RGMII
interfaces
10 Mb / 100 Mb / 1 Gb Ethernet is supported
An RJ45 connector with link and activity status is used with each
RGMII interface
IEEE 1588
precision time protocol (PTP) is supported through an
onboard header (J29)
Clocks System clock
(SYSCLK) and DDR
clock (DDRCLK)
100 MHz differential clock to DIFF_SYSCLK
100 MHz single-ended clock to DDRCLK
SerDes clocks
161.1328125 MHz clock to SerDes1 PLL 1 and PLL 2
100 MHz clock to SerDes2 PLL 1 and PLL 2
100 MHz clock to SerDes3 PLL 1 and PLL 2
100 MHz clock to AQR107 10 GbE PHY 1 and 2
25 MHz clock to IN112525 25 GbE PHY
156.25 MHz clock to CS4223 40 GbE PHY
100 MHz clock to x4 and x8 PCIe slots
Ethernet clocks 125 MHz clocks to Ethernet controllers and IEEE 1588 port
Power supplies
12 V, 5 V, 3.3 V, and 5 V (standby) ATX power supplies
0.8 V (VDD) for the LX2160A core
Table continues on the next page...
NXP Semiconductors
LX2160ARDB Overview
QorIQ LX2160A Reference Design Board Reference Manual, Rev. 4, 07/2020
Reference Manual 8 / 116

Table of Contents

Other manuals for NXP Semiconductors QorIQ LX2160A

Related product manuals