Oce VarioStream 7000 SINGLE - 5.6 Settings when changing paper (pinfed)

5.6 Settings when changing paper (pinfed)
A29246-X20-X-4-7680 / fa504_pinfed.fm 121
5.6 Settings when changing paper (pinfed)
5.6.1 Settings on paper transporter
5.6.1.1 Setting the calibration gap
5.6.1.2 Setting loop puller force
Proceed as follows:
1. Set GAP lever to the appropriate
position for the paper or printing media
used.
• Position NORMAL:
Normal position for paper weight
< 140 g/m
2
.
• Position OFF:
Paper weight >140 g/m
2
, labelpaper,
plastic cards.
Proceed as follows:
1. Use the turning knob to position the
indicator in the black area of the setting
scale which corresponds to the width
of the inserted paper.
For paper widths not listed, position
the indicator in the corresponding
intermediate position.