Oce VarioStream 7000 SINGLE - Creating a New Setup or Changing a Setup

5.8.1 Creating a new setup or changing a setup
134 A29246-X20-X-4-7680 / fa508.fm
5.8.1 Creating a new setup or changing a setup
Requirements for saving setups:
• The "key operator" or an operator authorized by the key operator must be logged in.
• There can be no error message present.
Proceed as follows:
1. If the printing system has not yet stopped, click the following button:
2. On the operator panel select:
• For universally valid print job setups:
<VarioStream> <Setup> menu
• For channel-specific setups:
<VarioStream> <Setup channel A / B / C> menu
3. Select setup in the "Setup List" tab.
4. If this setup is not yet loaded, click the following button:
5. Click "Setup Contents" tab and check settings.
6. Adjust settings as required in the menus under <VarioStream> <Configuration>.
1 of 2