6 Cleaning the printing system
A29246-X20-X-4-7680 / fa601.fm 175
6 Cleaning the printing system
6.1 Overview
This section shows you the intervals for cleaning the different assemblies.
Strictly observe the following safety information when cleaning:
Caution
The printer system could start unexpectedly if it is not in "Stop" status.
Ensure that the printing system is in the "Stop" status before you begin cleaning.
There can be a high build-up of static charge when vacuuming the toner spill.
Always use an industrial vacuum cleaner with a grounded suction tube, rubber nozzle
and filter set for fine dust. For draining large quantities of toner spill (such as a full
bottle), the industrial vacuum cleaner must be explosion-proof.
There is a danger of slipping on toner or developer spill.
Clean up toner and developer spill immediately.
The printing system can be damaged if incorrect cleaning materials or equipment are
used.
Only use specified cleaning materials and equipment (see section Cleaning materials
and equipment, page 365).
Important
Spilled toner is soiled.
Re-using spilt toner causes printing problems.
Never use spilled toner for printing.
To Next Page
Loading...
