7.3.10 Replacing the waste collector
326 A29246-X20-X-4-7680 / fa703.fm
7.3.10 Replacing the waste collector
The following procedure is for replacing the waste collector:
- Remove waste collector >>> page 326
- Install waste collector >>> page 328
Remove waste collector
Proceed as follows:
1. If the printing system has not yet stopped, click the following button:
2. Open side door of fuser station.
Caution
The components in the fuser station reach a surface temperature of approximately
230
o
C in operation.
If you touch them, you may burn yourself.
Do not touch any parts behind the safety covers identified with the icon .
3. Turn the knob of the oiling unit to the
left and swivel on oiling unit.
1 of 3
To Next Page
Loading...
