7.3.4.5 Replacing charge corotrons (torn wire)
A29246-X20-X-4-7680 / fa703.fm 281
7.3.4.5 Replacing charge corotrons (torn wire)
The printer detects the end of the corotrons' service life automatically and displays a
warning on the operator panel. The following procedure is for replacing the charge corotron:
• Remove torn charge corotron >>> page 281
• Install new charge corotron >>> page 282
Remove torn charge corotron
Important
Observe the safety directives before replacing corotrons (see section 7.3.4 Replacing
corotrons, page 269).
Proceed as follows:
Important
This section does not apply to the error message "HV error charge corotron".See
Abschnitt 7.3.4.5.
1. Pull out the handle of the corotron
mounting and push away from the PC
drum.
1 of 2
To Next Page
Loading...
