7.3.9 Replacing the pressure roller
320 A29246-X20-X-4-7680 / fa703.fm
7.3.9 Replacing the pressure roller
The following procedure is for replacing the pressure roller:
- Remove pressure roller >>> page 320
- Install pressure roller >>> page 323
Remove pressure roller
Caution
Observe the following safety directives when replacing the pressure roller:
The pressure roller may only be replaced by operators after training or instructions
from service personnel.
Proceed as follows:
1. If the printing system has not yet stopped, click the following button:
2. Select the <Replace consumables> <Replace pressure roller> menu on the operator
panel.
3. Click on the following button to start pressure roller replacement:
Information on the icons displayed on the operator panel under "Worksteps":
see section Icons, page 93
Note
Only if paper post-processing is connected:
Remove any deflection rollers that may be mounted on the stacker platform.
4. Cut inserted paper in the paper input at a right angle to the transport direction and
remove it from the printing system by continuously pressing the EJECT key.
5.
Lower the stacker top by pressing the right key under this icon .
1 of 3
To Next Page
Loading...
