5.4 Inserting paper (pinfed)
100 A29246-X20-X-4-7680 / fa502_pinfed.fm
5.4 Inserting paper (pinfed)
To insert paper, the printing system must be powered on, i.e. the main circuit breaker is in
position I and the POWER ON key is activated. The paper can be fed either via the internal
input tray or via the external central paper feed.
Proceed as follows:
1. Lift up cover hood.
2. Open the left and right door at the front of the printing system.
3. Only if replacing the paper stack before paper end click on the following button:
4. Cut the paper in the input tray in the
paper stack area.
To Next Page
Loading...
