Oce VarioStream 7000 SINGLE - Replacing the cleaning brush; Remove cleaning brush

7.3.3 Replacing the cleaning brush
264 A29246-X20-X-4-7680 / fa701.fm
The printing system detects the end of the cleaning brush's service life automatically and
displays a warning on the operator panel in good time. The following procedure is for
replacing the cleaning brush:
- Remove cleaning brush >>> page 264
- Install cleaning brush >>> page 267
Remove cleaning brush
Caution
• Do not allow toner to get into eyes. In the event of contact with eyes, rinse eyes out
with plenty of water and seek medical help.
• Avoid contact between the skin and the toner; wear gloves. In the event of contact
with the skin, wash toner off with plenty of water.
• Do not inhale toner. Avoid accumulation of dust. If, after inhaling toner, you
experience symptoms such as nausea, headaches or dizziness, immediately go out
into the fresh air.
• Always use an industrial vacuum cleaner with a grounded suction tube, rubber
nozzle and filter set for fine dust. For larger quantities of toner spill (e. g. full bottle),
the industrial vacuum cleaner must be explosion-proof.
• Keep cleaning brush out of the reach of children.
Important
Keep used cleaning brush ready for collection by service or the contracted shipping
company .
Proceed as follows:
1. If the printing system has not yet stopped, click the following button:
2. Select the <Replace consumables> <Replace cleaning brush> menu on the operator
panel.
1 of 4