6.6 Cleaning the soft fuser roller
A29246-X20-X-4-7680 / fa603.fm 199
6.6 Cleaning the soft fuser roller
Strictly observe the following safety directives when cleaning the fuser roller:
If there is toner residue on the fuser roller, the fuser roller must be cleaned.
Especially if paper has wrapped itself around the fuser roller, toner may be stuck on the
fuser roller.
Caution
• Clean soft fuser rollers only when they have cooled off, otherwise there is a danger
of burning. For this reason, allow the open fuser station to cool down for at least 30
minutes before cleaning the fuser roller.
• The cleaning agent is very flammable. Danger of fire!
• Do not allow developer to get into eyes. In the event of contact with eyes, rinse eyes
out with plenty of water and seek medical help.
• Do not breathe in the cleaning agent vapors. If you experience unpleasant
symptoms after inhaling, immediately go into the fresh air and, if necessary, call a
doctor.
• Keep cleaning materials out of the reach of children and store away from containers
used for food and drink.
Important
• Do not use hard objects for cleaning, as they may damage the fuser roller.
• Clean the soft fuser roller only with the prescribed cleaning agent (roller cleaner 6-
1508/W1/H).
Proceed as follows:
1. Power off printing system.
2. Open the front and side door of the fuser station.
Caution
The components in the fuser station reach a surface temperature of approximately
230
o
C in operation.
If you touch them, you may burn yourself.
Do not touch any parts behind the safety covers identified with the icon.
1 of 4
To Next Page
Loading...
