Oce VarioStream 7000 SINGLE - Logging on as User and Requesting the Access Ticket

4.3.2.1 Logging on as user and requesting the access ticket
A29246-X20-X-4-7680 / all_allg3.fm 85
4.3.2.1 Logging on as user and requesting the access ticket
To be able to set parameters on the operator panel, you must first log on as a user and then
request the access ticket.
The access ticket ensures that parameters are not set by different users at parallel operator
panels.
Note
If a user with a higher authorization level has already requested the access ticket, a
message will be displayed. From users with the same authorization level the access
ticket can be requested directly.
Proceed as follows:
1. Click the <General> <User> <Change user> menu.
2. Select the desired user in the selection list.
3. Enter password.
4. Click on the following button:
Only if several operator panels are connected to the printing system:
5. Click on the <General> <Access ticket> menu.
6. Click on the following button:
If the access ticket has already been requested, the button is deactivated.
Note
The access ticket can also be requested and released directly using the following but-
tons in the frame toolbar without going through the menu.