5.2 Powering on the printing system
96 A29246-X20-X-4-7680 / fa501.fm
5.2 Powering on the printing system
Note
If the optional High Temperature Kit is used, the external recooling system must be
powered on before powering on the printing system:
Proceed as follows:
1. Turn the main circuit breaker on the
right narrow side upwards to Position I.
2. Press the POWER ON button.
After pressing the POWER ON button,
wait until the booting information
appears on the operator panel.
During the boot phase, different
messages appear on the operator
panel in the basic menu.
1 of 3
To Next Page
Loading...
