7.3.7 Replacing the heater
302 A29246-X20-X-4-7680 / fa703.fm
7.3.7 Replacing the heater
The printing system detects when the heater is faulty and displays a warning on the
operator panel. The following procedure is for replacing the heater:
- Remove heater >>> page 302
- Install heater >>> page 307
Remove heater
Caution
Observe the following safety directives when replacing the heater:
The heater may only be replaced by operators after training or instructions from
service personnel.
Proceed as follows:
1. If the printing system has not yet stopped, click the following button:
2. Select the <Replace consumables> <Replace heater> menu on the operator panel.
3. Click the following button to start heater replacement:
Information on the icons displayed on the operator panel under "Worksteps":
see section Icons, page 93
4. Open the front and side door of the fuser station.
Caution
The components in the fuser station reach a surface temperature of approximately
230
o
C in operation.
If you touch them, you may burn yourself.
Do not touch any parts behind the safety covers identified with the icon .
1 of 5
To Next Page
Loading...
