Oce VarioStream 7000 SINGLE - Information on the Icons Displayed on the Operator Panel under Worksteps: See Section Icons; Open the Cover and both Doors at the Front of the Printing System; Open Door to Photoconductor Drum; Pull Lever Forward

7.3.3 Replacing the cleaning brush
A29246-X20-X-4-7680 / fa701.fm 265
3. Click on the following button to start cleaning brush replacement:
Information on the icons displayed on the operator panel under "Worksteps":
see section Icons, page 93
4. Open the cover and both doors at the front of the printing system.
Important
Put on the protective gloves provided in the packaging.
Do not touch the exterior of the cleaning brush; hold exclusively by the interior.
Place the cleaning brush down vertically only, with the brush hairs facing upwards.
5. Put on protective gloves.
6. Open door to photoconductor drum.
Pull lever forward.
7. Push safety lever to the right and open
door by lever.
Proceed as follows:
2 of 4