7.2.5 Replacing the fuser oil bottle
252 A29246-X20-X-4-7680 / fa701.fm
7.2.5 Replacing the fuser oil bottle
Strictly observe the following safety directives when replacing the fuser oil bottle:
The printer detects the end of the fuser oil supply automatically and displays a warning on
the operator panel. The following procedure is for replacing the fuser oil bottle:
- Remove fuser oil bottle >>> page 252
- Install the fuser oil bottle >>> page 254
Remove fuser oil bottle
Caution
• Do not allow fuser oil to get into eyes. In the event of contact with eyes, rinse eyes
out with plenty of water and seek medical help.
• Avoid contact with the skin. In the event of contact with the skin, wash fuser oil off
with plenty of water.
• Do not spill fuser oil. There is a danger of slipping on spilled fuser oil.
• If you do spill fuser oil, immediately apply an agent such as siliceous earth
(kieselguhr) to bind the fluid, and dispose of in a suitable manner.
• Keep fuser oil out of the reach of children and store it away from containers used for
food and drink.
Proceed as follows:
1. If the printing system has not yet stopped, click the following button:
2. On the operator panel select:
• Menu <Replace consumables> <Replace fuser oil bottle>
3. Click on the following button to start the fuser oil bottle replacement:
Information on the icons displayed on the operator panel under "Worksteps":
see section Icons, page 93
1 of 2
To Next Page
Loading...
