5.8.3 Exporting a setup
A29246-X20-X-4-7680 / fa508.fm 137
5.8.3 Exporting a setup
You can also export setups for other printing systems VarioStream 7000 SINGLE.
Requirements:
• The "key operator" or an operator authorized by the key operator must be logged in.
• A setup must be loaded. The loaded setup cannot be the "default" setup.
Proceed as follows:
1. If the printing system has not yet stopped, click the following button:
2. On the operator panel select:
• For universally valid print job setups:
<VarioStream> <Setup> menu
• For channel-specific setups:
<VarioStream> <VarioStream> menu
3. Select setup in the "Setup List" tab.
4. Click on the following button:
5. Select where the setup is to be exported:
• Floppy disk
• Transfer area (a directory on the <D: drive> of the SRA-controller hard disk, used
for the remote data transmission of setups)
6. If exporting to a floppy disk, insert a formatted floppy disk into the floppy disk drive of
the SRA controller.
7. Click on the following button:
To Next Page
Loading...
