5.8.2 Importing a setup
136 A29246-X20-X-4-7680 / fa508.fm
5.8.2 Importing a setup
You can apply setups created on another printing system VarioStream 7000 SINGLE.
Proceed as follows:
1. If the printing system has not yet stopped, click the following button:
2. On the operator panel select:
• For universally valid print job setups:
<VarioStream> <Setup> menu
• For channel-specific setups:
<VarioStream> <Setup channel A / B / C> menu
3. Click on the following button:
4. Select from where the setup is to be imported:
• Floppy disk
• Transfer area (a directory on the <D: drive> of the SRA-controller hard disk, used
for the remote data transmission of setups)
5. If importing from a floppy disk, insert the floppy disk with the setups into the floppy
disk drive of the SRA controller.
6. Select one or more setups in the dialog window.
7. Click on the following button:
To Next Page
Loading...
