Oce VarioStream 7000 SINGLE - Safety Covers; Cleaning; Foreign Bodies, Noises

2.6.2.2 Safety covers
A29246-X20-X-4-7680 / all203.fm 33
• Do not work with unprotected long hair or wear loosely hanging items of clothing (e. g.
ties, sleeves, scarves et. c.), or jewelry such as necklaces, bracelets and rings, since
these can catch in the drive mechanisms or moving parts of the printing system and
cause injury.
2.6.2.2 Safety covers
• Do not attempt to remove safety covers yourself; do not manipulate safety equipment
such as the switches monitoring the safety covers, fuses etc., and do not perform any
work not intended to be performed by operators. Such action can cause accidents and
may also damage the printing system.
• Safe operation of the printing system is guaranteed only when the outer paneling is fully
mounted. Only properly and fully affixed housing ensures:
– Protection from electrical shocks
– Protection against injury from mechanical parts, e. g. cuts, drawing in, crushing
– Protection against the spread of fire
– Sufficient cooling of the printing system.
• Keep all doors, trims, flaps and covers closed while the printing system is in operation.
This ensures that limit values for radio interference suppression are not exceeded. Noise
emission is also minimized.
2.6.2.3 Cleaning
• Observe the instructions in section 6 Cleaning the printing system for cleaning the printing
system.
• For vacuuming, an industrial vacuum cleaner with grounded suction device, rubber noz-
zle and a filter insert for fine dustmust be used. When vacuuming large quantities of toner
spill (e. g. 1 bottle), an explosion-proof industrial vacuum cleaner must be used because
there can be a high build-up of static charge when draining toner spill.
• Only use the recommended cleaning agents and equipment (see section Cleaning ma-
terials and equipment, page 365).
2.6.2.4 Foreign bodies, noises
• Make sure that no objects (e. g. jewelry chains, paper clips, coins etc.) or liquids get into
the interior of the printing system, since this may result in electric shocks or short circuits.
Do not place objects on the printing system, and especially do not place containers with
fluid, such as drinking bottles, glasses, cups or vases on top of or in the immediate vicinity
of the printing system.