7.3.7 Replacing the heater
A29246-X20-X-4-7680 / fa703.fm 303
5. Turn the knob of the oiling unit to the
left and swivel on oiling unit.
Caution
The components in the fuser station reach a surface temperature of approximately
230
o
C in operation.
If you touch them, you may burn yourself.
Allow the printing system to cool down for at least 30 minutes.
6. Allow printing system to cool down for at least 30 minutes.
7. Lift up the active filter unit on the right
side using the handle and swivel out by
the rotary axle.
Proceed as follows:
2 of 5
To Next Page
Loading...
