7.2.5 Replacing the fuser oil bottle
A29246-X20-X-4-7680 / fa701.fm 255
4. Close the center door at the back of the printing system.
5. Click the following button to complete filling the developer at the operator panel:
All printing system assemblies are checked (duration approx. 2-3 minutes) before
the printing system is switched to the "Ready" status.
In both cases, the message on the operator panel is automatically deleted, and the
replacement of the fuser oil bottle is recorded in the <Consumables history> menu.
Proceed as follows:
2 of 2
To Next Page
