7.3.1 Replacing the photoconductor drum
258 A29246-X20-X-4-7680 / fa701.fm
Remove photoconductor drum
Proceed as follows:
1. If the printing system has not yet stopped, click the following button:
2. On the operator panel select:
• Menu <Replace consumables> <Replace photoconductor drum>
3. Click on the following button to start the PC drum replacement:
Information on the icons displayed on the operator panel under "Worksteps":
see section Icons, page 93
4. Open the cover and both doors at the front of the printing system.
5. Open door to photoconductor drum.
Pull lever forward.
1 of 3
To Next Page
Loading...
