Technical data
A29246-X20-X-4-7680 / faA01.fm 369
• Preprinted forms must not contain metal pigmented
printing ink on the front or reverse side.
• The printing ink must be heat resistant (approx. 240° C
for printing 7.5 x 10
5
N/m
2
) and non-abrasive.
Thermoplastic particles must not be released.
• The printing ink must be completely dried through.
• If a preprinted surface is to be used for printing:
– the surface must be rastered
– the coverage must be less than 50%
Coated papers Coated papers must not contain components that could
be released when heated (240° C and higher).
Self-adhesive labels Continuous forms for labels:
– Weight: 90 g/m
2
to 180 g/m
2
– Cut edges must be clean
– Minimal abrasion
– Minimal dust
Label paper:
–Weight: ≥ 65 g/m
2
– Volumes: 1.3 cm
3
/g ± 0.2 cm
3
/g
Carrier paper:
– Coated reinforced paper
– Weight: 85 g/m
2
± 4%
– Volumes: 1.3 cm
3
/g ± 0.2 cm
3
/g
Compound:
– Adhesives must be heat-stable at the fuser
temperature.
Adhesiveness of labels on the carrier paper:
0.1 per 15 mm
Storage conditions Temperature: 18°C to 24°C
Relative humidity: 35% to 55%
To Next Page
