Omron CQM1H - PROGRAM User Manual

462
Host Link Commands Section 6-5
Parameters Status Data, Message (Response)
“Status data” consists of four digits (two bytes) hexadecimal. The leftmost
byte indicates CPU Unit operation mode, and the rightmost byte indicates the
size of the program area.
The “Message” parameter is a FAL/FALS number that exists when the com-
mand is executed. When there is no message, this parameter is omitted.
6-5-24 STATUS WRITE –– SC
Changes the PC operating mode.
Command Format
Response Format An end code of 00 indicates normal completion.
15 14 13 12 11 10 9 8
00 00
98
00
10
1
1
x 16
3
x 16
2
This area is different
from that of STATUS
WRITE.
Bit
Bit
1: FALS generated
1: Fatal error generated
Operation mode
PROGRAM mode
RUN mode
MONITOR mode
76543210
1000
x 16
1
x 16
0
65
00
00
4
0
1
Bit
Bit
None
Program area write-protection
0: Write-protected
1: Not write-protected
Program area
4 Kbytes
01
0
8 Kbytes
(In CQM1H PCs, turn DIP switch pin 1
ON to write-protect the program area.)
100
16 Kbytes
@ SCx 10
0
x 10
1
x 16
1
x 16
0
↵
*
Node No. Header
code
TerminatorFCS
Mode data
@ SCx 10
0
x 10
1
x 16
1
x 16
0
*
↵
TerminatorFCS
Node No. Header
code
End code

Omron CQM1H - PROGRAM Specifications

General

Brand	Omron
Model	CQM1H - PROGRAM
Category	Controller
Language	English