Omron CQM1H - PROGRAM User Manual

466
Host Link Commands Section 6-5
Note The area specified under “Name” must be in four characters. Add spaces
after the data area name if it is shorter than four characters.
6-5-28 MULTIPLE FORCED SET/RESET –– FK
Force sets, force resets, or cancels the status of the bits in one word in the IR,
SR, LR, HR, AR, or TC area.
Command Format
Response Format An end code of 00 indicates normal completion.
Parameters Name, Word address (Command)
In “Name,” specify the area (i.e., IR, SR, LR, HR, AR, or TC) that is to be
forced set or reset. Specify the name in four characters. In “Word address,”
specify the address of the word that is to be forced set or reset.
Name Classification Word address setting range Bits
OP1 OP2 OP3 OP4
C I O (Space) IR or SR 0000 to 0252 00 to 15
(decimal)
L R (Space) (Space) LR 0000 to 0063
H R (Space) (Space) HR 0000 to 0099
A R (Space) (Space) AR 0000 to 0027
T I M (Space) Completion Flag (timer) 0000 to 0511 Always 00
T I M H Completion Flag (high-speed timer)
T T I M Completion Flag (totalizing timer)
C N T (Space) Completion Flag (counter)
C N T R Completion Flag (reversible counter)
@ FKx 10
0
x 10
1
x 10
3
x 10
2
x 10
1
x 10
0
OP1 OP2 OP3 OP4
↵
15 14 13 12 11 10 1 0
Node
No.
Header
code
Name Word
address
Forced set/reset/cancel data
Bit
x 16
0
x 16
0
x 16
0
x 16
0
x 16
0
x 16
0
x 16
0
x 16
0
Te r m i n a t o rFCS
*
@ FKx 10
0
x 10
1
x 16
1
x 16
0
*
Node
No.
Header
code
TerminatorFCSEnd code
↵
Name Classification Word address setting range Bits
OP1 OP2 OP3 OP4
C I O (Space) IR or SR 0000 to 0252 00 to 15
L R (Space) (Space) LR 0000 to 0063
H R (Space) (Space) HR 0000 to 0099
A R (Space) (Space) AR 0000 to 0027
T I M (Space) Completion Flag (timer) 0000 to 0511 Always 15
T I M H Completion Flag (high-speed timer)
T T I M Completion Flag (totalizing timer)
C N T (Space) Completion Flag (counter)
C N T R Completion Flag (reversible counter)

Omron CQM1H - PROGRAM Specifications

General

I/O Capacity	Up to 512 points
Power Supply	100 to 240 VAC, 50/60 Hz or 24 VDC (depending on model)
Instruction Set	Basic and advanced instructions
Operating Temperature	0 to 55°C
Program Capacity	7.2K to 15.2K steps
Communication Ports	RS-232C
Expansion Slots	Up to 3 expansion units
Type	Programmable Logic Controller (PLC)
CPU Type	RISC
Program Memory	7.2K to 15.2K steps
I/O Points	512 max
Expansion Capability	Up to 3 expansion units
Data Memory	RAM (battery backup)