150
Initial Setting Level Section 7-5
Settings
7-5-14 Auxiliary Output 4 Allocation (sub4)
Condition: Analog output models only
Function This parameter allocates the data to be output to the auxiliary output 4 termi-
nals (terminals 16 and 18.)
Communications
Settings
7-5-15 Operation after Power ON (cont)
Function • This parameter selects either “stop” or “continue” for the E5ZN operation
after the power has been turned ON.
• The operation after a software reset or when moving from initial setting
level to operation level depends on the “stop” or “continue” selection
made using this parameter.
Settings range Default
00000000H (0) ch1 Heating control output 12: PV transfer
output for ch1
00000001H (1) Cooling control output
00000002H (2) Alarm 1 and sensor error alarm OR
output
00000003H (3) Alarm 2 output
00000004H (4) Alarm 3 output
00000005H (5) ch2 Heating control output
00000006H (6) Cooling control output
00000007H (7) Alarm 1 and sensor error alarm OR
output
00000008H (8) Alarm 2 output
00000009H (9) Alarm 3 output
0000000AH (10) ch1 SP transfer output
0000000BH (11) Ramp SP transfer output
0000000CH (12) PV transfer output
0000000DH (13) Heating MV transfer output
0000000EH (14) Cooling MV transfer output
0000000FH (15) ch2 SP transfer output
00000010H (16) Ramp SP transfer output
00000011H (17) PV transfer output
00000012H (18) Heating MV transfer output
00000013H (19) Cooling MV transfer output
ch Variable type Address
Shared C3 0030 or 0130
Setting range Default
Refer to the table of setting
ranges for auxiliary output 3
allocation.
17: PV transfer output for ch2
To Next Page
Loading...
