Omron E5ZN - 5-9-12 RAM Data Save; 5-9-13 Software Reset

83
Commands and Responses Section 5-9
5-9-12 RAM Data Save
Command
This command writes operation/adjustment level setting data to internal non-
volatile memory. Refer to 6.3
6-3 Setup Level Configuration and Front Panel
Keys
for information on operation/adjustment level.
This command can be used for either setting area 0 or 1.
Before executing the command, use an operation command to enable com-
munications writing.
Response
Response code: The code shown above represents normal completion. For
details on the response code, refer to
5-7 Operation Commands.
5-9-13 Software Reset
Command
This command triggers a software reset, which returns the Temperature Con-
troller to its initial state when it was turned ON.
This command can be used in either setting area 0 or 1.
Before executing the command, use an operation command to enable com-
munications writing.
Response The Temperature Controller does not return a response to this command.
MRC
“30” “05”
SRC
Command
code
Related
information
“05”
“00” or “10”
MRC SRC
Response code
“30” “05” “0000”
MRC
“30” “05”
SRC
Command
code
Related
information
“06”
“00” or “10”