Omron E5ZN - Setup Level Configuration and Front Panel Keys

114
Setup Level Configuration and Front Panel Keys Section 6-3
6-3 Setup Level Configuration and Front Panel Keys
Parameters are divided into groups called levels. Each of the set values
(setup items) in these levels are called a parameter. The parameters on the
E5ZN are divided into the following seven levels:
OK: Indicates items that can be set.
Note To move to the advanced function setting level, set the “initial setting/communications
protection” parameter in the “protect level” to “0.”
Of these levels in normal mode, the initial setting level, communications set-
ting level, and advanced function setting level can be used only when control
has stopped. Controller outputs are stopped when any of these four levels are
selected.
It is possible to enter copy mode while Controller outputs are being made, but
copy operations (e.g., upload, download) can by used only when control has
stopped.
Mode/Level Control in
progress
Control
stopped
Normal
mode
Protect level OK -
Operation level OK -
Adjustment level OK -
Initial setting level - OK
Advanced function setting level - OK
Communications setting level - OK
Copy mode - OK
Operation level Adjustment level
Power ON
Protect level
Copy
Mode
Control stops.
Password input
set value "-169"
Control in progress
Control stopped
Level +
Mode Keys
3 seconds
min.
Level +
Mode Keys
1 second min.
Level Key
Less than
1 second
Normal mode
Level Key
1 second
min.
Level Key
The PV display flashes after one second.
Level Key
Less than
1 second
Level Key
1 second min.
Initial
setting level
Communications
setting level
Advanced function
setting level
Copy Key
Less than
1 second
Copy Key
1 second
min.
Level Key 3 seconds min.