84
Commands and Responses Section 5-9
5-9-14 Move to Setting Area 1
Command
Use this command to move to setting area 1.
Use this command in setting area 0. If the Temperature Controller is in setting
area 1 when the command is received, the command is ignored.
If the set value of the “initial setting/communications protection” parameter is
2 (indicating that moving to initial setting or communications setting level is
disabled) when the Temperature Controller receives the command, the Tem-
perature Controller returns an error.
Before executing this command, use an operation command to enable com-
munications writing.
Response
Response code: The code shown above represents normal completion. For
details on the response code, refer to
5-7 Operation Commands.
5-9-15 Move to Protect Level
Command
This command moves the Temperature Controller to the protect level. Refer to
6-3 Setup Level Configuration and Front Panel Keys for information on protect
level.
This command can be used in setting area 0 only. If the Temperature Control-
ler is in setting area 1 when the command is received, it returns an error.
Before executing the command, use an operation command to enable com-
munications writing.
Response
Response code: The code shown above represents normal completion. For
details on the response code, refer to
5-7 Operation Commands.
MRC
“30” “05”
SRC
Command
code
Related
information
“07”
“00” or “10”
MRC SRC
Response code
“30” “05” “0000”
MRC
“30” “05”
SRC
Command
code
Related
information
“08”
“00” or “10”
MRC SRC
Response code
“30” “05” “0000”
To Next Page
Loading...
