76
Commands and Responses Section 5-9
5-9-3 Multiple Reads of Monitor Values/Setting Data
Command
Multiple monitor values or setting data values can be read with the execution
of one command. Up to 5 values can be read, even if the addresses are not
consecutive.
Refer to
5-10 Variable Area Map for information on specifying variable types
and addresses.
This command can be used in either setting area 0 or 1.
No data will be read if an area type error or parameter error occurs in any of
the data.
Response
Response code: The code shown above represents normal completion. For
details on the response code, refer to
5-5 Read from Variable Area.
Variable
type
Address Monitor value/setting data
ch Description
“C0” “0000” to “0006” 1 Monitor value
“0100” to “0106” 2
“C1” “0000” to “0019” 1 Setting data for setting area 0
“0100” to “0119” 2
“C3” “0000” to “003E” 1 Setting data for setting area 1
“0100” to “013E” 2
“C5” “0000” 1 Setting data for setting area 0
“0100” 2
“C7” “0000” to “0001” 1 Setting data for setting area 1
“0100” to “0101” 2
MRC SRC
Variable
type Address
Bit
position
“01” “04” “00”
Variable
type Address
Bit
position
Variable
type Address
Bit
position
“00”
“00”
MRC SRC
Response code Data
Variable
type
Data
Variable
type
“01” “04” “0000”
Typ e
Monitor value/setting data
Typ e
Monitor value/setting data
To Next Page
Loading...
