144
Initial Setting Level Section 7-5
7-5-2 Scaling Upper Limit (in-h)
Scaling Lower Limit (in-l)
Decimal Point (dp)
Condition: The input type must be set to analog input.
Function • These parameters can be used when a voltage input is selected as the
input type.
• When a voltage input is selected as the input type, scaling is performed.
Set the upper limit in the “scaling upper limit” parameter and the lower
limit in the “scaling lower limit” parameter.
• The “decimal point” parameter specifies the decimal point position of
parameters (e.g., SP) whose unit is set to EU.
Communications
Settings
See Also
• Related Parameter
“Input type” (initial setting level) (page 143)
7-5-3 °C/°F Selection (d-u)
Condition: The input type must be set to temperature input.
Function • Set the temperature input unit to either °C or ° F.
• The temperature input unit must be the same for both ch1 and ch2.
Communications
Settings
Setting ch Variable type Address
Scaling upper limit 1 C3 0001
2 C3 0101
Scaling lower limit 1 C3 0002
2 C3 0102
Decimal point position 1 C3 0003
2 C3 0103
Setting Settings range Unit Default
Scaling upper limit Scaling lower limit +1 to 00000270FH
(Scaling lower limit +1 to 9,999)
- 100
Scaling lower limit FFFFF831H to scaling upper limit −1
(−1999 to scaling upper limit −1)
-0
Decimal point
position
00000000H to 00000001H (0 t0 1) - 0
ch Variable type Address
Shared C3 0004 or 0104
Setting range Unit Default
00000000H to 00000001H
0: °C (c)
1:
°F (f)
-
0:
°C
To Next Page
Loading...
