Omron E5ZN - Setting the SP; Changing the SP

28
Setting the SP Section 3-5
3-5 Setting the SP
3-5-1 Changing the SP
Use host communications or the E5ZN-SDL Setting Display Unit to set the SP.
Default is 0
°C.
In this example, the SP will be changed from 0
°C to 200°C.
• Use host communications to set the “SP” parameter to “000000C8H
(200°C).”
• To use the Setting Display Unit to change the SP, select the channel to be
changed and use the Up and Down Keys to set the SP to 200°C
.
• To start control, an operation start (RUN) must be specified after changing
the SP. Refer to 3-10 Starting and Stopping Control for details.